According to some clinical studies, insufficient cement distribution (ID) in the fractured area and asymmetrical cement distribution around the fractured area were thought to be the reasons for unrelieved pain and recollapse after percutaneous vertebral augmentation (PVA) in the treatment of symptomatic osteoporotic vertebral compression fractures. Finite element methods were used to investigate the biomechanical variance among three patterns of cement distribution (ID and sufficient cement distribution in the fractured area and asymmetrical cement distribution around the fractured area including upward [BU] and downward [BD] cement distribution). Compared with fractured vertebra before PVA, distribution of von Mises stress in the cancellous bone was transferred to be concentrated at the cancellous bone surrounding cement after PVA, whereas it was not changed in the cortical bone. Compared with sufficient cement distribution group, maximum von Mises stress in the cancellous bone and cortical bone and maximum displacement of augmented vertebra increased significantly in the ID group, whereas asymmetrical cement distribution around the fractured area in BU and BD groups mainly increased maximum von Mises stress in the cancellous bone significantly. Similar results could be seen in all loading conditions. ID in the fractured area may lead to unrelieved pain after PVA in the treatment of symptomatic osteoporotic vertebral compression fractures as maximum displacement of augmented vertebral body increased significantly. Both ID in the fractured area and asymmetrical cement distribution around the fractured area are more likely to induce recollapse of augmented vertebra because they increased maximum von Mises stress in the cancellous bone and cortical bone of augmented vertebra significantly. Copyright © 2015 Elsevier Inc. All rights reserved.